|
LDSS152 lifting and sliding door
1. Huajian profile 2. Combination angle glue injection process 3. Micro ventilation system |
1. Drainage and windproof seals for design;
2. The PA66+25% glass fiber nylon bar is adopted, and the push-and-pull sash joint is designed with insulation plastic material;
3. The key part is designed with seal measures applicable to the area where the rain and typhoon frequently happen;
4. Moisture separation isobaric rubber strip, separated external watertight chamber and indoor air-tight chamber
5. The special die-casting duct corner meets the corner link requirement at different angles with combination angle glue injection to strengthen the corner link
6. Notch standardization: fitting notch, line pressing notch, duct corner notch, rubber strip notch, installation notch and sealing notch
7. The hollow glass with different thicknesses and multi-cavity insulated aluminum profile are adopted to lower the resonance effect of sound wave.
Material: 6063-T5 primary aluminum
Wall thickness: 2.0mm
Glass: Double glass 6+16A+6/5+27A+5
Hardware: Siegenia/G-U/Sobinco
Rubber strip: Automotive ternary ethylene propylene rubber strip
1. Huajian profile 2. Combination angle glue injection process 3. Micro ventilation system
4. High cost performance 5. Stepped drainage 6. Type C heat insulation plaster design
7. Mullion workmanship 8. Multi-cavity heat insulation plaster 9. Soft-hard co-extrusion isobaric rubber strip
Structure width: 101mm Base material wall thickness: ≥1.5mm
Wind load resistance: Level 9 Air impermeability: Level 6 Water tightness: Level 3
Heat retaining property: Level 6 Acoustical insulation: Level 2
